If a page moves up briefly while you are scrolling down, look for the same reversal in the tester below. Scroll in one direction at a time and pause before switching directions.
Scroll continuously in one direction at a time inside the test area.
Reverse Jumps: 0
↑ 0 · ↓ 0 · ← 0 · → 0
What an isolated reverse pulse means
A mechanical scroll encoder uses contact signals to distinguish direction. Dust or wear can disrupt the contact sequence and lead to a report in the opposite direction. The tester marks patterns such as ↓ ↓ ↓ ↑ ↓ in the recent signal once the original direction resumes. A fresh run in the other direction helps separate an isolated reversal from an intentional change.
| What you observe | Likely explanation | Next check |
|---|---|---|
| The page scrolls in the opposite direction consistently | Scroll direction preference | Check Windows, macOS, or the device profile |
| A single application or browser extension changes scrolling | Smooth scrolling, extension, or driver settings | Try another application and restore the default mouse profile |
| Reverse pulses recur in repeated same-direction passes on two computers | Dirty or worn encoder | Clean around the wheel and retest, then request service if it persists |
Clean and retest
Turn off or unplug the mouse and use short bursts of compressed air around the wheel as you rotate it. Reconnect it, reset the app or vendor scroll settings to defaults, and retest. If you suspect the vendor software, disable its profile temporarily or follow its official driver reset instructions.
Use the full scroll wheel tester to check both vertical directions and any horizontal tilt inputs. If repeatable reversals survive cleaning and a cross-device check, consider warranty service or an encoder repair.