Start by reading the exact model and receiver. A Viper V3 Pro and a DeathAdder V3 HyperSpeed do not have the same dongle requirements.
Check the receiver and connection mode
The Viper V3 Pro ships with its HyperPolling receiver. Razer lists up to 8000 Hz with that receiver. The DeathAdder V3 HyperSpeed can use a compatible HyperPolling receiver sold separately. In both cases, check the manufacturer's limit for the connection mode you are actually testing.
Isolate the stutter
- Charge the mouse and use a direct USB connection or place the receiver near the mouse with the extension. Move it away from USB 3.x drives and hubs.
- In Synapse, use a known profile and start at 1000 Hz where the device supports it. Compare the same motion with the same DPI, surface, and app load. If behavior happens only after idle, check any sleep settings shown for your exact model.
- Try wired mode where supported, then repeat wireless on a second computer. Compare actual stutters and the test stream, and check firmware guidance for the exact model.
A lower browser reading can come from event delivery, motion, or the wireless link. Use the full polling test and receiver interference comparison to isolate one variable at a time.